Instruction Manual

REASSEMBLING YOUR RIFLE…

Pg. 40

REASSEMBLING YOUR RIFLE…REASSEMBLING YOUR RIFLE… (Continued)

8. Insert Charging Handle into Upper Receiver

and lower the “ears” at front end of Handle

into cutouts in Receiver. Then slide Charging

Handle partially into Receiver.

9. Lower complete Bolt Carrier Assembly into Upper

Receiver. Gas Key will fit into groove in the

Charging Handle.

REMEMBER, Bolt

must be

pulled to “out” position in the Carrier so Cam Pin

will fit into the channel in the Upper Receiver.

10. Then slide

the Bolt Carrier Assembly and

Charging Handle all the way into the Upper

Receiver until Charging Handle Latch locks

onto the Receiver.

NOTE:

If Ejection Port Cover is closed, you will

feel some resistance as you push Carrier

and Handle in until you pop the Cover

open. If Cover is already open, Handle and

Carrier should slide in easily.

0_Placed.qxd 12/28/07 3:30 PM Page 40