Instruction Manual

REASSEMBLING YOUR RIFLE…
GAPS IN GAS RINGS
BOLT
BODY
4. At the back end of the Bolt, stagger the Gas
Ring Gaps to reduce gas pressure loss.
Position the three ring gaps 120° apart around
the bolt (3rd gap not seen at back side of bolt).
The rings will slide around in their groove by
pushing them into position with a small sharp
object.
5.
Insert Bolt into Bolt Carrier. Twist into
position so Cam Pin can be inserted
(remember Cam Pin can only be installed in
Bolt from one side, so if it doesn’t fit right
away, twist the Bolt 180° and try again).
6.
Once Cam Pin is inserted, twist it 90° (this
will allow insertion of the Firing Pin).
WARNING: THE CAM PIN MUST BE INSTALLED IN THE BOLT GROUP.
IF IT ISN’T, YOUR RIFLE CAN STILL FIRE AND WILL EXPLODE!
Pg. 38
REASSEMBLING YOUR RIFLE…REASSEMBLING YOUR RIFLE… (Continued)
0_Placed.qxd 12/28/07 3:30 PM Page 38