Instruction Manual

LUBRICATION – BOLT CARRIER GROUP…
Pg. 36
LUBRICATION – ADJUSTABLE REAR SIGHT…LUBRICATION – ADJUSTABLE REAR SIGHT…
NOTE: Record how far you move the Rear Sight so it can be returned to its original position upon the
completion of this task.
Rear
Sight
Moving Parts: Use 1 or 2 drops of CLP. Rotate these parts to ensure that the lubricant is spread
evenly above, below and around the threads of the:
1.
Elevation Knob
2.
Elevation Screw Shaft
3.
Windage Knob
4. Windage Screw
5.
Detent Holes
Elevation Screw
Shaft:
Also lube
from inside the
Upper Receiver as follows:
1.
Turn Upper Receiver upside down.
2.
Remove Charging Handle.
3.
Put 2 or 3 drops on bottom of Elevation Screw
Shaft and in Elevation Detent Spring Hole.
4.
Rotate the Elevation Dial back and forth a few
times while keeping Upper Receiver upside-down.
WINDAGE
KNOB
ELEVATION
DIAL
WINDAGE
SCREW
BOTTOM OF ELEVATION SCREW
SHAFT AND DETENT SPRING HOLE
DETENT
SPRING
HOLE
0_Placed.qxd 12/28/07 3:30 PM Page 36