Instruction Manual

Firing Pin: Lightly lubricate the Firing Pin with CLP - also the
Firing Pin recess in the Bolt.
Bolt: Generously lubricate
the Bolt, its Cam Pin area, the Bolt
Gas Rings. A lighter application is good on the Extractor
and it’s Pin.
Charging Handle: Lightly lubricate the Charging
Handle and it’s Latch and Spring.
Bolt Carrier: Lightly lubricate the inner and outer
surfaces of the Bolt Carrier. Generously
lubricate the Cam Pin area and the “Slide” Rail
areas of the Bolt Carrier where they contact
the inside of the Receiver.
CARRIER KEY
SLIDE RAIL AREAS (each side)
LATCH
Carrier Key: The inside of the Carrier Key on the
Bolt Carrier should be dried with a Q-Tip or
Pipe Cleaner - then place one drop of CLP
inside.
Pg. 35
LUBRICATION – BOLT CARRIER GROUP…LUBRICATION – BOLT CARRIER GROUP…
LUBRICATION – ADJUSTABLE REAR SIGHT…
0_Placed.qxd 12/28/07 3:30 PM Page 35