Instruction Manual

1. Clean all areas of Powder Fouling, Corrosion, Dirt
and Rust. Again, never use a wire brush or any type
of abrasive to clean the Aluminum Lower Receiver.
2. Wipe
any dirt from the Trigger Mechanism.
Carefully clean the Magazine Release Button and
the cavity for the Magazine Catch on the left side of
the Receiver. Also inspect and clean the Bolt Catch
Mechanism and Receiver’s Takedown and Pivot
Pins. Clean the Buffer, Action Spring, and inside the
Lower Receiver Extension (the Buffer Tube). A piece
of rag attached to the Cleaning Rod and Patch
Holder can be used to wipe inside the Buffer Tube.
3. If
rifle has been used in very dirty/muddy
conditions, the Vent Screw in the A2 Solid
Buttstock (shown) or the Vent Hole in the Telestock
Receiver Extension may need to be cleaned out.
Use a Pipe Cleaner or piece if wire to ensure that
Vent Hole is clear.
4.
Buttstocks may require cleaning as necessary. Telescoping Stock Latch can be
pulled down to remove Stock. Clean the 6 Position Lock Holes, and lightly lube the
Receiver Extension and Latch Mechanism to ensure proper telescoping action. A2 Solid
Buttstocks may require cleaning / lubrication of Storage Compartment Door Latch and
Hinge, and interior of Storage Compartment.
CLEAN INSIDE
OF
BUFFER TUBE
CLEAN OUT
DRAIN HOLE
IN THE
BUTTPLATE
SCREW
Pg. 33
CLEANING THE LOWER RECEIVER…CLEANING THE LOWER RECEIVER…
LUBRICATION – UPPER & LOWER RECEIVERS…
0_Placed.qxd 12/28/07 3:30 PM Page 33