Instruction Manual

6. After one pull, take off the handle section and repeat the process. After three or four
pulls, the three rod sections and the Bore Brush may become screwed tightly
together. Loosen them up and repeat the process.
7.
Send a patch through the Bore occasionally to help clean out the crud that the brush
is getting loose. Just replace the Bore Brush with the Rod Tip (Patch Holder) and a
wet patch. Pull it through. If you leave the rods loose again, the patch will "track" in
the rifling as before. But remember, always have the Bore
wet with
cleaner before
trying to pull a brush through.
ATT
ACH HANDLE
AND PULL THROUGH
FROM CHAMBER
TO MUZZLE
Pg. 29
DETAILED CLEANING TECHNIQUES…DETAILED CLEANING TECHNIQUES… (Continued)
CLEANING THE UPPER RECEIVER…
0_Placed.qxd 12/28/07 3:30 PM Page 29