Instruction Manual

WARNING… IF A NOTICEABLE DIFFERENCE IN SOUND OR RECOIL IS EXPERIENCED, STOP FIRING.
Either condition could indicate an incomplete powder burn and/or a bullet stuck in the bore. Retract
the Bolt slowly and remove the fired cartridge case. Clear the weapon and check for unburned powder grains
in the Receiver or Bore, and for a Bullet stuck in the Bore (see Page 17). Clean out any unburned powder
before resuming firing. If a Bullet is stuck in the Bore, do not attempt to remove it. Take the Rifle to a qualified
Gunsmith.
CONDITION: Rifle
is
now Loaded, a Round is Chambered, and Safety Selector should be on
SAFE
.
CAUTION: ALWAYS POINT THE MUZZLE IN A SAFE DIRECTION!
To FIRE the Rifle in SEMI-AUTOMATIC MODE (one Round fired with each pull of
the Trigger), move the Safety Selector from
SAFE to
FIRE
.
Aim at
Target – Pull Trigger – Release.
The Rifle will automatically eject the spent Cartridge and chamber another in
preparation for the next shot. The cycle of pulling the Trigger to shoot, and the
Rifle automatically reloading, can be continued until the Magazine is empty.
NOTE:
After the last Round is fired, the Bolt Carrier will lock in the rear position. You can then push the
Magazine Release Button to drop out the empty magazine, insert a fresh Magazine, release the Bolt Catch,
and a new Round will be automatically chambered in preparation for the next firing sequence.
Pg. 13
OPERATION OF YOUR RIFLE…OPERATION OF YOUR RIFLE… (Continued)
IMMEDIATE ACTIONS — IN CASE OF TROUBLE!
0_Placed.qxd 12/28/07 3:30 PM Page 13