Instruction Manual

1. Use only quality 5.56mm or .223 Remington Ammunition suitable for
your firearm. Examine each Cartridge - particularly around the primer.
Look for dents, scratches, and other signs of damage.
DO NOT
LOAD DAMAGED AMMUNITION!
2.
With the
Magazine facing forward as shown in the illustration, place a
Round between the Feed Lips of the Magazine with the Bullet Tip forward. Push the
Round down until it is held by the Magazine Feed Lips.
3. If necessar
y, give the Round a slight push backward to seat it against the inside
back edge of the Magazine Feed Lips. Place next Round on top of the previous
Round and repeat steps until desired number of Rounds are loaded into Magazine.
CAUTION:
Safe Firearms Handling dictates that you
ONLY
LOAD LIVE AMMUNITION
INTO YOUR RIFLE WHEN YOU ARE ABOUT TO SHOOT.
3.
Place Selector
Lever in
FIRE
position. Pull the Trigger.
THE HAMMER
SHOULD FALL.
NOTE:
For purposes
of the following check, “SLOW” is defined as one fourth to one half
the normal rate of trigger release.
4. Hold T
rigger to the rear, pull Charging Handle to the rear and release Charging Handle.
Then release pressure on the Trigger with a slow, smooth motion, without hesitations
or stops, until the Trigger is fully forward.
AN AUDIBLE
CLICK SHOULD BE HEARD - THE HAMMER SHOULD NOT FALL.
5.
Repeat the FIRE
position test
FIVE TIMES
. The Rifle must not malfunction during any of these five tests. If
the Rifle malfunctions during any of these five tests, have the Rifle checked by a qualified gunsmith.
Pg. 9
SAFETY FUNCTION CHECK…SAFETY FUNCTION CHECK… (Continued)
PREPARING TO FIRE - LOADING A MAGAZINE…PREPARING TO FIRE - LOADING A MAGAZINE…
OPERATION OF YOUR RIFLE… LOADING
INSERTING A MAGAZINE…
0_Placed.qxd 12/28/07 3:30 PM Page 9