Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 BUSHMASTER M17S Bullpup OPERATION AND SAFETY INSTRUCTIONS ® Bushmaster Firearms, Inc. Quality Parts Co. P.O.
Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 WARNING! THINK SAFE DANGEROUS WEAPONS Semi-automatic rifles are classified as FIREARMS or DANGEROUS WEAPONS and are sold by Bushmaster Firearms, Inc. with the specific understanding that we are not responsible in any manner whatsoever for their improper or negligent handling or resale under local laws and regulations. Bushmaster Firearms, Inc.
Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 LIMITED WARRANTY... It is our intention under normal conditions to warrant any and all defects in parts, material or workmanship which affect the satisfactory operation of the rifle. Our warranty obligation is limited to the repair or replacement of any part(s) which is returned to us and is determined by us to be defective. We assume no liability for any incidental or consequential damage.
Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 SAFETY WARNINGS ! THESE ARE ALL IMPORTANT SAFETY WARNINGS. THINK PLEASE NOTE WARNING SYMBOLS FOUND SAFE THROUGHOUT THIS MANUAL. These safety warnings are for your protection as well as the safety of others. Disregarding information in this manual may result in THINK serious injury or death. SAFE Do not attempt to load or use any firearm until you have read and understand the information contained in this manual.
Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 • Keep all firearms and ammunition out of reach of children. • Store firearms and ammunition separately. • Never store a loaded gun and always separate Upper and THINK Lower Receiver and remove Bolt Carrier. SAFE • Never leave a loaded firearm unattended. • Never carry a loaded firearm in a vehicle. A firearm's safety button is a mechanical device which can never replace safe gun handling.
Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 CONTENTS: A. GENERAL DESCRIPTION - Page 7 1. Type of Weapon 2. Technical Data 3. Ammunition 4. Main Groups B. SAFETY MODE SELECTION - Page 8 C. STRIPPING AND ASSEMBLING - Page 8 1. Stripping 2. Assembling 3. Check Function 4. Cleaning D. LOADING, FIRING AND UNLOADING WEAPON - Page 11 1. Loading 2. Firing 3. Loading after last round fired 4. Unloading E. PARTS LIST AND EXPLODED DRAWING - Page 14 F.
Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 OPERATING INSTRUCTIONS Read and understand this entire manual and its safety warnings BEFORE firing the rifle. THINK SAFE A. GENERAL DESCRIPTION A1. Type of Weapon... The Bushmaster M17S Bullpup is a gas operated Semi-Automatic rifle. It fires from the locked bolt position and the design makes it a short, handy rifle with high accuracy and reliability. A2. Technical Data... Caliber ........................................
Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 B. SAFETY MODE SELECTION When the safety catch is pushed flush with the left side of the Lower Receiver, a WHITE line can be seen on the right side of the Lower Receiver. The rifle is now in SAFE mode. When the safety catch is pushed flush with the right side of the Lower Receiver, a RED line can be seen on the left side of the Lower Receiver. The rifle is now in FIRE mode.
Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 Step 3. Removing the Bolt Carrier Group. Holding the pistol grip, use the thumb and two fingers of the left hand to grip the exposed action plate. Withdraw bolt carrier by pulling up and out. Do not strip Bolt Carrier any further. Removing the Ignition Pocket is a complex operation. It is recommended that it be carried out only by a qualified gunsmith. THINK SAFE C2. Assembling Bolt Carrier Group to Upper Receiver...
Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 Step 2. Closing the Rifle Cock the hammer onto the sear with the left hand. Hold the end of the upper receiver with the left hand with the thumb pressing on the action plate to keep it level with the end of the receiver. Swing the upper receiver down until the action plate is retained by the face of the lower receiver. Remove thumb and fully close the rifle.
Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 2. Plastic Parts and Metal Parts Plastic parts and the upper receiver are cleaned with a soft rag. If necessary, use water for cleaning. The bolt carrier and ignition pocket are cleaned with a soft brush. To increase the life of the rifle and ensure proper functioning, some metal parts have to be oiled slightly after cleaning. Use only lubricants specially designed for firearms. Avoid abrasives.
Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 Inserting Magazine... Cocking... Place left hand in the space between the carry handle and slide rearward as far as possible. When the furthermost point of this motion is reached, remove hand to allow the cocking handle to slide forward. The cocking handle will automatically return to its previous position to form part of the carry handle. This cocks the action and makes the gun READY TO FIRE.
Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 Should the ammunition fail to fire, keep the rifle pointed in a safe direction. Slide safety to SAFE position. Do not refire shell. Slide cocking handle rearwards. The problem round THINK SAFE will be ejected and a new round automatically selected. NOTE: Spent cartridges are ejected from the right of the rifle through the ejection port.
Page 14 30-216 - Trigger Roll Pin 30-217 - Safety 30-218 - Trigger Cam 30-219 - Trigger Cam Roll Pin 30-221 - Trigger Bar 30-222 - Cover Plate 30-224 - Cocking Spring 30-230 - Scope Mount 30-231 - Rail 30-232 - Rail Retaining Screw (4 per gun) 30-301 - Breech Bolt 30-302 (MS16562-98) - Ejector Roll Pin 30-303 (8448512 - Extractor Cartridge 30-304 (8448513) - Extractor Pin 30-305 (8448755sp) - Extractor Spring 30-306 - Firing Pin 30-307 - Firing Pin Spring (deleted 1998) 30-308 - Cam Pin 30-309 - Bolt Carrie
Bushmaster M17S Bullpup Exploded Drawing 1 - Ejector Roll Pin (#30-302) 1 - Extractor Cartridge (#30-303) 1 - Extractor Pin (#30-304) 1 - Extractor Spring (#30-305) 1 - Firing Pin (#30-306) 1 - Cam Pin (#30-308) 1 - Ejector Cartridge (#30-310) 1 - Firing Pin Ret. Pin (#30-311) 2 - Action Springs (#30-315) 2 - Action Rod Retainers (#30-316) 1 - Extractor Spring Insert (#30-321) 2 - Tkdwn Pin Detents (#30 410) 2 - Tkdwn Pin Det.
Bushmaster Bullpup Operation & Safety Instructions Downloadable version - July 1999 SERVICE INSTRUCTIONS Should your firearm require service that necessitates shipping to an authorized service center, please follow these instructions. THINK BE ABSOLUTELY SURE THAT THE FIREARM IS NOT LOADED! SAFE Ship the firearm in a sturdy gun case or appropriate padded container. Do not send accessories, scopes or optics with the firearm. Wrap all pieces, if disassembled, in protective wrapping (foam or bubblepak).
