Operating and Safety Manual

RE-CONFIGURING THE FIREARM (cont’d.)
42
7. Remove the Bolt Carrier and disassemble (See page 22).
8. Select proper bolt head for caliber Firearm is being converted to.
9. Install Bolt into Bolt Carrier.
10. Reassemble Bolt Carrier.
11. Ensure Bolt Carrier is removed from action or is locked to the rear.
12. Select the proper barrel for the caliber rifle is being converted to.
13. Guide the Barrel Extension into the Trunnion. The piston will pass through an
opening in the Trunnion.
14. Guide the Barrel Lock Handle to the right until it engages with the Trunnion. Once seated
into the Trunnion, turn the barrel locking lever clockwise until there is a positive stop
(you may have to depress the Barrel Plunger to start rotation). The Barrel Locking Ring will
make audible clicks as the torque is being applied for proper installation.
15. Install Hand Guard over the Barrel Assembly and push Hand Guard Retaining Pin closed to
lock into place.
16. Insert Bolt Carrier into the Upper by aligning the notches on the Bolt Carrier with the Bearing
Rails inside the Upper. Move forward until the Locking Lugs engage the Barrel Extension.
17. Select the proper Magazine and follow instructions for operating the Firearm (See page 10).
CALIBER CONVERSION