Operating and Safety Manual

WARNING: BEWARE OF DANGEROUS PROCEDURES
• Be sure Cam Pin is installed in the Bolt Group. If it isn’t, your Firearm can still fire and COULD
MALFUNCTION CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR DEATH
.
• When using a
Blank Firing Attachment, NEVER FIRE ANYTHING EXCEPT BLANKS! For your
safety, we recommend the visible, military style blank firing attachment (BFI Part# RAY-008).
• If your firearm stops firing with a live round in the chamber of a hot barrel (a misfire),
REMOVE
THE ROUND FAST!
However, if you cannot remove it within 10 seconds, remove magazine and
wait 15 minutes
with the Firearm pointing in a SAFE DIRECTION! This way you won’t be hurt
by a possible round “cooking-o” (i.e. the round detonating just from the heat of the barrel).
Keep your face away from the ejection port while clearing a hot chamber.
• If your bolt fails to unlock, and you try to free it by tapping the buttstock on the ground while pulling
on the charging handle,
keep yourself clear of the Muzzle and the Firearm pointed down range.
• If there is water in the barrel, do not fire the rifle. IT COULD MALFUNCTION CAUSING
PROPERTY DAMAGE, PERSONAL INJURY OR DEATH
.
• Pull the charging handle to the rear to break the seal to ensure the water will run o from
the chamber through the ejection port area.
• If a noticeable dierence in sound or recoil is experienced,
STOP FIRING! Either condition could
indicate an incomplete powder burn and/or a bullet or other obstruction stuck in the bore.
• Take the Firearm to a qualified gunsmith and have obstructions removed.
•
NOTE: With the Bolt Carrier Assembly locked to the rear, or in its forward position, if the Firearm is
dropped or jarred with a loaded magazine in place, a live round could be chambered.
2
ALWAYS PRACTICE SAFE FIREARMS HANDLING!