Operating and Safety Manual

REASSEMBLING YOUR FIREARM… (cont’d.)
35
CAUTION: BUSHMASTER DOES NOT RECOMMEND THE PRACTICE OF SWAPPING
BOLTS BETWEEN DIFFERENT FIREARMS. DOING SO COULD RESULT IN
MALFUNCTION CAUSING PROPERTY DAMAGE,
PERSONAL INJURY OR DEAT
H.
11. Insert Bolt Carrier assembly into the Upper by
aligning the notches on the Carrier with the Bearing
Rails inside the Upper. Move forward until the
locking lugs engage the Trunnion.
12. To join Upper and Lower Receivers, position Pivot
Pin Lug of Upper Receiver into slot at front of
Lower Receiver and push Pivot Pin into place.
CAUTION: Always place the Safety Selector Lever on SAFE before pivoting the Upper
Receiver to a closed position on the Lower Receiver.
13. After Receivers are closed, push in Takedown Pin.
14. To ensure proper reassembly, perform the safety function check (See page 8) prior to
any attempt to fire the Rifle.
If the Sling, or any other Accessories were removed for cleaning or maintenance,
they should be reattached now.
SLING REATTACHMENT…