Operating and Safety Manual

CLEANING THE LOWER RECEIVER…

1. Clean all areas of Powder Fouling, Corrosion, Dirt and

Rust. Again, never use a wire brush or any type of

abrasive to clean the proprietary composite polymer

Lower Receiver.

2. Stocks may require cleaning as necessary and should

be cleaned with mild detergent and water. Dry stock

or let air dry after it has been

cleaned.

1. Insert Piston Rod

and Piston Spring

through Gas Block

and Piston Rod

through Guide Block.

3. Attach the Barrel

Assembly by guiding the

Barrel Extension into the

Trunnion. The piston will

pass through an opening

in the Trunnion.

2. Insert Gas

Regulator and

rotate to either

“U” or “S”

REASSEMBLING YOUR FIREARM…