Operating and Safety Manual

DISASSEMBLING YOUR FIREARM…

(cont’d.)

9. Remove Cam Pin by turning Bolt Carrier on the side

and tapping opposite side of Bolt Carrier. Cam Pin should fall out.

10. Remove Bolt Assembly

from Bolt Carrier by

pulling straight out.

12. Remove Extractor

with Spring.

11. Remove Extractor Pin by pushing out with a punch or the tip of a Bullet.

NOTE:

Press rear of Extractor to check Spring function.

CAUTION:

Extractor Spring may pop out and get lost!

DISASSEMBLE USING STEPS 11 AND 12 ONLY WHEN DIRTY OR DAMAGED