Operating and Safety Manual

DISASSEMBLING YOUR FIREARM…
21
1. CLEAR YOUR FIREARM! (as described on Page 6). Disconnect the Sling for convenience.
2. Push the Rear Takedown Pin (a Bullet Tip can help) as far as it will go.
Pivot Upper Receiver from Lower Receiver.
5. Push the Charging Handle fully forward to
disconnect the Actuator from the Bolt Carrier.
Remove Bolt Carrier to the rear.
4. Separate Upper and
Lower Receivers
.
3. Push in Pivot Pin (a Bullet Tip can help).
NOTE: Pivot Pin in the Lower Receiver and Takedown Pin in the Upper Receiver are “captivated”
- meaning that they are held in by their Detents and Springs so they cannot fall out and get lost.