Operating and Safety Manual

ZEROING YOUR SIGHTS…

(cont’d.)

5. If you need to raise your next shot group to get closer to the bullseye, rotate the Front

Sight Post clockwise one click. A Front Sight Adjustment Tool (Part# RAY-005 - see

Bushmaster Catalog or Website) is recommended for this but not necessary – the sight

can be adjusted with the tip of a Bullet as shown at right. One click will move the bullet

strike point one vertical square on the target sheet.

6. If you need to lower your next shot group, rotate the Front Sight Post counterclockwise.

(One click - as before – equals one square.) Changes in Windage are made with the Windage

Knob on the Rear Sight. To move the shot group to the left, turn the Windage Knob counter-

clockwise. To move the shot group to the right, turn the Windage Knob clockwise

7. Carefully aim and ﬁre another

group at the center of the

target bullseye. Repeat Steps

5 and 6 as required to get your

shot groups into the bullseye.

8. Once your shot group is on

target, your Sights are zeroed,

or “calibrated”.

Elevation Adjustment Table

a. Sight Radius: 14.1 in.

b. Bullet Strike Adjustment:

Impact Distance

0.485 in./click 25m

1.939 in./click 100m

5.817 in./click 300m

Windage Adjustment Table

a. Sight Radius: 14.1 in.

b. Bullet Strike Adjustment:

Impact Distance

0.323 in./click 25m

1.293 in./click 100m

3.878 in./click 300m