Operating and Safety Manual

SAFETY FUNCTION CHECK…
UNLOAD FIREARM - REMOVE MAGAZINE - CHECK CHAMBER
1. Remove Magazine if installed. Pull Charging Handle assembly to rear. Check that Chamber is
clear. Let the Bolt and Bolt Carrier close. Do not pull Trigger. Leave Hammer in cocked position.
WARNING! If Firearm fails any of the following tests, continued use of the Firearm could cause a
malfunction causing personal injury, property damage or death
.
2
. Place Selector Lever in SAFE position, point rifle in a safe direction,
and pull the Trigger.
THE HAMMER SHOULD NOT FALL .
3. Place Selector Lever in FIRE position. Pull the Trigger.
THE HAMMER SHOULD FALL.
NOTE:
For purposes of the following check, “SLOW” is defined
as one fourth to one half the normal rate of trigger release.
4. Hold Trigger to the rear, pull Charging Handle to the rear and release Charging Handle. Then
release pressure on the Trigger with a slow, smooth motion, without hesitations or stops, until
the Trigger is fully forward
.
AN AUDIBLE CLICK SHOULD BE HEARD - THE HAMMER SHOULD NOT FALL.
5. Repeat the FIRE position test FIVE TIMES . The Firearm must
not malfunction during any of these five tests. Pull the
Charging Handle to the rear one last time and release forward
.
6. Place the Selector Lever in SAFE position. Pull the Trigger.
THE HAMMER SHOULD NOT FALL.
If the Firearm malfunctions during any of these five tests, have the Firearm checked by a qualified gunsmith.
8