Instruction manual

Troubleshooting
17
Problem Potential Reasons What to do
No picture
No Picture
No Sound
The Remote Control is
not responding
Power isn't connected
Power is not on
Video Cables not connected
Picture Settings are incorrect
Audio Cables are not
connected
Mute function is on
There are obstructions between
the remote control and the
sensor
Connect the power
Switch on the power
Ensure Video Cables are
connected properly
Conduct a Factory Reset to
clear all Settings
Connect the Audio Cables
as outlined
Turn off mute by pressing Mute
Button again or by increasing the
volume
Replace the batteries
Move any obstructions between
the remote control and the sensor
and ensure you follow the remote
instructions
The Batteries are dead
Record function is not
available
Disk space is full already.
No disk detected.
The format of Disk is not
supported.
Check the Disk before recording.
ensure the format of disk is FTA32.
If using USB device,ensure the
USB version is higher than 2.0.
Please Note:
- Not all USB devices may be supported by this unit and we assume no responsibility for any loss of
data that may occur.
- Large data files may take longer to read, please be patient while the USB loads.
- Some USB devices may not be recognised as the unit will only support USB devices with the FAT32
file system.
- We recommend formatting the USB first before recording. Please follow the below instructions on
how to format your USB.
D. PVR configure
Once your USB Device has been inserted into the side of the unit, press the Menu Button and then press
the (Left/Right) Navigation Buttons to select USB mode. Press the Enter Button to confirm and enter the
USB mode. Then use the (Up/Down) Navigation Buttons to select the "PVR configure" Menu and then
press the Right Navigation Button to enter the "PVR configure" Menu. This Menu will allow you to
format your USB device and ensure it is ready for recording.
In PVR Configure mode, you will be asked to do the following;
[RECORD DEVICE]:This will allow you to set your USB device to record. Use the (Up/Down) Navigation
Buttons to select the "RECORD DEVICE" option and press the Right Navigation Button to enter the
"RECORD DEVICE" option and automatically set the USB for recording.
[FORMAT]:This will allow you to format and clear your USB for recording. Use the (Up/Down)
Navigation Buttons to select the "FORMAT" option and then press the Right Navigation Button to enter
the "FORMAT" option. Press the Enter Button to begin formatting your USB Device.