Operating Instructions

92 OPERATION
You can now proceed to regis-
ter all the remote controls.
Step through the following
procedure with each remote
control in turn:
Hold down buttons 1 and 2.
LED 3 flashes for about ten
seconds.
Once LED 3 no longer flashes,
release buttons 1 and 2.
3 LED lights up.
Press button 1 or button 2.
One sound signal is issued
and the LED 3 goes out.
To complete logon:
Switching off the ignition
( 59).
Three sound signals are is-
sued.
The logon is also ended in the
following situations:
4 remote controls have been
logged on.
After logon of the first re-
mote control, no button was
pressed for approx. 30 sec-
onds.
Synchronizing the remote
controls
with central locking system
OE
with anti-theft alarm system
(DWA)
OE
without Keyless Ride
OE
If the central locking system
stops responding to the signals
from a remote control unit then
the unit will need to be resyn-
chronized. This scenario can
arise (for example) after the
remote-control unit's buttons
have been pressed frequently
while the unit was beyond the
range of the DWA.
Synchronize the remote-con-
trol units as follows:
Switching on the ignition
( 58).
Hold down buttons 1 and 2.
LED 3 flashes for about ten
seconds.
Once LED 3 no longer flashes,
release buttons 1 and 2.
3 LED lights up.