Operating Instructions
Table Of Contents
- Table of Contents
- General instructions
- Overviews
- Displays
- Operation
- Ignition switch/steering lock
- Ignition with Keyless Ride
- Emergency-off switch
- Lighting
- Dynamic Traction Control (DTC)
- Electronic chassis and suspension adjustment (D-ESA)
- Riding mode
- Cruise control
- Distance control (ACC)
- Hill Start Control
- Anti-theft alarm system (DWA)
- Tire pressure control (RDC)
- Heating
- Storage compartment
- Central locking system
- Cases
- TFT display
- Audio system
- Setting
- Riding
- Technology in detail
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
45
Sensor faulty or system fault
with tire pressure monitor
(TPM)
OE
lights up yellow.
"---"
Possible cause:
Wheels without TPC/RDC sen-
sors are mounted.
Retrofit wheel set with TPC/
RDC sensors.
Possible cause:
1 or 2 RDC sensors have failed
or a system fault has occurred.
Have fault eliminated at a
specialist service facility,
preferably an authorized
BMW Motorrad retailer.
Battery of the tire pressure
sensor weak
with tire pressure monitor
(TPM)
OE
TPM sensors battery
low. Function lim-
ited. Have checked by a
specialist workshop.
This fault message is only
shown for a short time
immediately following the Pre-
Ride-Check.
Possible cause:
The battery for the tire inflation
pressure sensor is no longer
charged to full capacity. Oper-
ation of the tire inflation pres-
sure control is only ensured for
a limited time.
Contact an authorized service
facility, preferably an autho-
rized BMW Motorrad retailer.
Fall sensor defective
lights up yellow.
Fall sensor faulty.
Have checked by a
specialist workshop.
Possible cause:
The fall sensor is not function-
ing.
Contact a specialist work-
shop, preferably an authorized
BMW Motorrad retailer.
Side stand monitoring faulty
lights up yellow.
Side stand monitor-
ing faulty Onward
journey possible. Stop
engine when stationary!
Have checked by work-
shop.