Operating Instructions

44 DISPLAYS
Before adjusting the tire pres-
sure, check the information
on temperature compensation
and tire pressure adjustment
in the "Technology in detail"
chapter ( 182).
The target tire pressures can
be found in the following lo-
cations:
On the back cover of the op-
erating instructions
Instrument cluster in the TIRE
PRESSURE view
Sign on the left fork leg
Have the tire checked by a
specialist workshop for dam-
age, preferably by an autho-
rized BMW Motorrad retailer.
If you are unsure about the
tire's drivability:
Do not continue riding.
Contact roadside service.
Transmission fault
with tire pressure monitor
(TPM)
OE
"---"
Possible cause:
The motorcycle has not
reached the minimum speed
( 182).
RDC sensor is not active
min 19 mph (min 30 km/h)
(The RDC sensor does not
transmit a signal to the mo-
torcycle until this minimum
speed has been exceeded.)
Watch the RDC display at
higher speed. A continuous
error is only present if the
general warning lamp also
lights up. In this case:
Have fault eliminated at a
specialist service facility,
preferably an authorized
BMW Motorrad retailer.
Possible cause:
There is a fault in the radio
connection to the RDC sensors.
Possible causes are radio sys-
tems in the surrounding area,
which interfere with the con-
nection between the TPC/RDC
control unit and the sensors.
Observe the RDC display in a
different environment. A con-
tinuous error is only present if
the general warning lamp also
lights up. In this case:
Have fault eliminated at a
specialist service facility,
preferably an authorized
BMW Motorrad retailer.