Operating Instructions
Table Of Contents
- Table of Contents
- General instructions
- Overviews
- Displays
- Operation
- Ignition switch/steering lock
- Ignition with Keyless Ride
- Emergency-off switch
- Lighting
- Dynamic Traction Control (DTC)
- Electronic chassis and suspension adjustment (D-ESA)
- Riding mode
- Cruise control
- Distance control (ACC)
- Hill Start Control
- Anti-theft alarm system (DWA)
- Tire pressure control (RDC)
- Heating
- Storage compartment
- Central locking system
- Cases
- TFT display
- Audio system
- Setting
- Riding
- Technology in detail
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Declaration Of Conformity
We declare
under our responsibility that the product
BMW Keyless Ride ID Device (Model: HUF5750
)
camplies with the appropriate essential requirements of the article 3
of the R&TIE and the other relevant provisions, when used for its
intended purpose. Applied Standards:
1. Health and safety requirements contained in article
3 (1) a)
• EN 60950-1:2006+A11:2009+A1:2010+A12:2011;
Information technology equipment-Safety
2. Protection requirements with respect to electromagnetic
compatibility article 3 (1) b)
• EN 301 489-1 (V1 .9.2, 09/2011 ), Electromagnetic
compatibility and radio spectrum matters (ERM);
Electromagnetic compatibility (EMC) standard for radio
equipment and services;
Part 1: Common technical requirements
• EN 301 489-3 (V1.4.1, 08/2002) Electromagnetic
compatibility and radio spectrum matters (ERM);
Electromagnetic compatibility (EMC) standard for radio
equipment and services; Part 3: Specific conditions for short
range devices (SRD) operating on frequencies between 9 kHz
and 40 GHz
3. Means of the efficient use of the radio frequency spectrum
article 3 (2)
• EN 300 220-1 & -2 (V2.4.1, 05/2012), electromagnetic
compatibility and radio spectrum matters (ERM); Short range
devices (SRD); Radio equipment tobe used in the 25 MHz to
1000 MHz frequency range with power Ieveis ranging up to
500 mW;
Part 1: Technical characteristics and test methods.
Part 2: Harmonized EN covering essential requirements under
article 3.2 ofthe R&TIE directive










