Operating Instructions
Table Of Contents
- Table of Contents
- General instructions
- Overviews
- Displays
- Operation
- Ignition switch/steering lock
- Ignition with Keyless Ride
- Emergency-off switch
- Lighting
- Dynamic Traction Control (DTC)
- Electronic chassis and suspension adjustment (D-ESA)
- Riding mode
- Cruise control
- Distance control (ACC)
- Hill Start Control
- Anti-theft alarm system (DWA)
- Tire pressure control (RDC)
- Heating
- Storage compartment
- Central locking system
- Cases
- TFT display
- Audio system
- Setting
- Riding
- Technology in detail
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
238 TECHNICAL DATA
TROUBLESHOOTING CHART
Engine does not start.
Possible cause Remedy
Side stand extended and gear
engaged
Retract side stand.
Gear engaged and clutch not
disengaged
Place transmission in neutral or
disengage clutch.
No fuel in tank Refueling procedure ( 160).
Battery drained Charging connected battery
( 214).
Overheating protection for
starter motor has activated.
Starter motor can only be actu-
ated for a limited period.
Leave the starter motor to cool
down for around 1 minute un-
til it becomes available again.
Bluetooth connection is not established.
Possible cause Remedy
Necessary pairing steps were
not performed.
Refer to the operating
instructions of the communica-
tion system for the necessary
steps for pairing.
The communication system is
not connected automatically
despite successful pairing.
Switch off the communication
system of the helmet and con-
nect again after one to two
minutes.
Too many Bluetooth devices
are stored in the helmet.
Delete all pairing entries in
the helmet (see the operating
instructions of the communica-
tion system).
There are additional vehicles
with Bluetooth-capable devices
nearby.
Avoid simultaneous pairing
with multiple vehicles.