Operating Instructions
Table Of Contents
- Table of Contents
- General instructions
- Overviews
- Displays
- Operation
- Ignition switch/steering lock
- Ignition with Keyless Ride
- Emergency-off switch
- Lighting
- Dynamic Traction Control (DTC)
- Electronic chassis and suspension adjustment (D-ESA)
- Riding mode
- Cruise control
- Distance control (ACC)
- Hill Start Control
- Anti-theft alarm system (DWA)
- Tire pressure control (RDC)
- Heating
- Storage compartment
- Central locking system
- Cases
- TFT display
- Audio system
- Setting
- Riding
- Technology in detail
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
208 MAINTENANCE
Radial brake calipers on
telescopic forks
28 lb/ft (38 Nm)
Remove adhesive tape from
wheel rim.
WARNING
Brake pads do not contact
the brake disc
Risk of accident due to de-
layed braking effect.
Before driving off, check
that the braking effect kicks
in without any delay.
Engage the brakes repeatedly,
continuing until the brake
pads make contact with the
discs.
Insert the wheel speed sensor
cable into the holding clips 1
and 2.
Insert the wheel speed sensor
into the bore and install the
screw 3.
Wheel speed sensor on
fork
Joint compound: Micro-
encapsulated or medium-
strength screw lock
6 lb/ft (8 Nm)
Attach the front-wheel
cover 1, paying attention to
the hook 2.
Install screws 1 on left and
right.
Front-wheel cover at
rear front-wheel cover
1 lb/ft (1 Nm)
Removing the rear wheel
Make sure ground is level and
firm and place the motorcycle
on its center stand.
Engage first gear.
Swiveling out the silencer
( 210).