Operating Instructions
Table Of Contents
- Table of Contents
- General instructions
- Overviews
- Displays
- Operation
- Ignition switch/steering lock
- Ignition with Keyless Ride
- Emergency-off switch
- Lighting
- Dynamic Traction Control (DTC)
- Electronic chassis and suspension adjustment (D-ESA)
- Riding mode
- Cruise control
- Distance control (ACC)
- Hill Start Control
- Anti-theft alarm system (DWA)
- Tire pressure control (RDC)
- Heating
- Storage compartment
- Central locking system
- Cases
- TFT display
- Audio system
- Setting
- Riding
- Technology in detail
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
200 MAINTENANCE
Topping up coolant
Remove screws 1.
Pull the front side trim
panel 1 outward.
Holding pins 3 are pulled out
of grommets.
Pull the side trim panel 1 up-
ward out of the side section 4
and remove it. When doing
so, pay attention to the lugs 2.
Open the cap 1 of the coolant
expansion tank and top up
coolant to the specified level.
Checking coolant level
( 199).
Close the cap of the coolant
expansion tank.
Attach the side trim panel 1
with lugs 2 on the side sec-
tion 4.
Make sure that the rub-
ber sleeves are correctly
installed and not pressed out
during installation.
Swivel side trim panel 1 in-
ward.
Holding pins 3 are pushed
into grommets.