Operating Instructions
Table Of Contents
- Table of Contents
- General instructions
- Overviews
- Displays
- Operation
- Ignition switch/steering lock
- Ignition with Keyless Ride
- Emergency-off switch
- Lighting
- Dynamic Traction Control (DTC)
- Electronic chassis and suspension adjustment (D-ESA)
- Riding mode
- Cruise control
- Distance control (ACC)
- Hill Start Control
- Anti-theft alarm system (DWA)
- Tire pressure control (RDC)
- Heating
- Storage compartment
- Central locking system
- Cases
- TFT display
- Audio system
- Setting
- Riding
- Technology in detail
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
198 MAINTENANCE
If the brake fluid level falls be-
low the approved level:
Have the defect rectified as
quickly as possible by a spe-
cialist workshop, preferably an
authorized BMW Motorrad re-
tailer.
Checking the rear brake fluid
level
WARNING
Insufficient or contaminated
brake fluid in the brake fluid
reservoir
Considerably reduced braking
power caused by air, dirt or
water in the brake system
Stop riding immediately until
fault is rectified.
Check brake fluid level regu-
larly.
Make sure that the lid of
the brake fluid reservoir is
cleaned before opening.
Make sure that brake fluid
is used from a sealed con-
tainer only.
Make sure ground is level and
firm and place the motorcycle
on its center stand.
Removing suspension strut
cover ( 191).
Check brake fluid level at
brake fluid reservoir for rear
wheel brake 1.
The brake fluid level in the
brake-fluid reservoir drops
due to brake pad wear.
Rear brake fluid level
Brake fluid, DOT4
The brake fluid level must
not fall below the MIN mark.
(Brake fluid reservoir hori-
zontal, motorcycle standing
upright)