Operating Instructions
Table Of Contents
- Table of Contents
- General instructions
- Overviews
- Displays
- Operation
- Ignition switch/steering lock
- Ignition with Keyless Ride
- Emergency-off switch
- Lighting
- Dynamic Traction Control (DTC)
- Electronic chassis and suspension adjustment (D-ESA)
- Riding mode
- Cruise control
- Distance control (ACC)
- Hill Start Control
- Anti-theft alarm system (DWA)
- Tire pressure control (RDC)
- Heating
- Storage compartment
- Central locking system
- Cases
- TFT display
- Audio system
- Setting
- Riding
- Technology in detail
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index

161
ATTENTION
Contact of fuel and plastic
surfaces
Damage to surfaces (become
unattractive or cloudy)
Immediately clean plastic
surfaces after contact with
fuel.
Make sure the ground is level
and firm and place the motor-
cycle on its center stand.
Open the protective cap 2.
Unlock the fuel tank cap in a
clockwise direction using the
ignition key 1 and fold it up.
with central locking system
OE
Press down the unlocked lock
cylinder and open the cap of
the fuel tank.
Refuel with a fuel meeting the
specifications above, continu-
ing until fuel is no higher than
lower edge of the fuel filler
neck.
If refueling is carried out
after running on fuel re-
serve, the resulting filling ca-
pacity must be greater than the
fuel reserve so that the new
fill level is detected and the
fuel reserve indicator light is
switched off.
The "usable fuel quantity"
specified in the technical
data is the fuel quantity, which
can be refueled if the fuel tank
was completely emptied, i.e., if
the engine dies off due to lack
of fuel.
Usable fuel quantity
Approx. 6.6 gal (Approx.
25 l)










