Instruction manual

9 Appliances
94 Touring - 03/11-1 - englisch (EN) - 0731070 - HYW-0102-01EN
Filling with fresh water:
Close the boiler drain cock (Fig. 76,1).
Open all water taps and set to "Warm" posi-
tion. Water pump is pumping water into the
boiler.
Leave all water taps on until water is free of
bubbles. Boiler is filled with water.
Close the water taps.
Gas operation:
Remove cap from waste gas vent.
Open the regulator tap on the gas bottle and
the gas isolator tap "Boiler".
Switch on boiler by turning the rotary switch
(Fig. 77,3) to " " (Fig. 77,5). The green
"Operation" indicator lamp illuminates the
knob (Fig. 77,1). The red indicator lamp
(Fig. 77,2) illuminates when there is a fault
(see chapter 14).
Adjust the knob (Fig. 77,1) to the required
water temperature.
Turning off:
Set rotary switch (Fig. 77,3) to " "
(Fig. 77,4).
Close the gas isolator tap "Boiler" and the
regulator tap on the gas bottle.
Place cap on waste gas vent.
The red indicator lamp (Fig. 77,2) illuminates
when there is a fault (see chapter 14).
Electrical operation:
Connect the vehicle to the 240 V power sup-
ply and switch on the 240 V automatic cir-
cuit breaker.
Set switch (Fig. 78,1) to on. Indicator lamp
on the switch is illuminated.
The water in the boiler is heated up to approx.
65 °C.
Fig. 76 Drain cock boiler
Fig. 77 Operating switch for Truma boiler
(gas operation)
Fig. 78 Operating switch for Truma boiler
(electrical operation)