Instruction manual

9 Appliances
88 Touring - 03/11-1 - englisch (EN) - 0731070 - HYW-0102-01EN
9.2.3 Heater (Variant 2)
The control knob (Fig. 70,1) has the following
positions:
- Off:
- Large flame: P
- Lighting position:
Turning on:
Open the regulator tap on the gas bottle and
the gas isolator tap "Heater".
Turn control knob (Fig. 70,1) on the heater
to the lighting position and press it firmly.
Fig. 70 Heater (variant 2)
The automatic ignition produces ignition sparks. A clicking noise can be heard.
Keep the control knob pressed until there is a flame. Press down for another 10 seconds to acti-
vate thermocouple.
Leave the heating in the lighting position for approx. one minute.
Set heat output at the control knob between lighting position and large flame.
Turning off:
Turn the control knob (Fig. 70,1) on the heater to "0". The automatic ignition is switched off si-
multaneously.
If the heating is not to be used for an extended period, close the main regulator tap on the gas
bottle and the "Heater" gas isolator tap.
> In case of problems wait for two minutes before trying again.
> The automatic ignition sparks until the gas ignites. If there is no gas, it will continue to
spark until the battery feeding it is empty. When the heating is not required, set the
control knob to "0" to avoid the battery running flat.
> If the clicking noise cannot be heard at all or only in intervals of several seconds during
ignition: change the battery.
> Further information can be obtained from the separate "TRUMA gas heater" instruc-
tion manual.