Instruction manual

12 Customer Service and Maintenance
122 Touring - 03/11-1 - englisch (EN) - 0731070 - HYW-0102-01EN
12.5 Spare Parts
For safety reasons, spare parts for pieces of equipment must correspond with manufacturer’s in-
structions and be permitted by the manufacturer as a spare part. These spare parts may only be fit-
ted by the manufacturer or an authorised workshop. Our ERIBA dealers and service centres are
available for any spare parts requirement. However, spare parts cannot be shipped ex factory.
Here are some suggestions of important spare parts:
- Fuses (ratings see chapter 8)
- Bulbs
- Water pump
When ordering spare parts please indicate the serial number and the caravan type to the ERIBA
dealer. The caravan described in this instruction manual is built and equipped according to work
standards. Special equipment is offered depending on its purpose or use. When fitting special equip-
ment check if such equipment has to be entered in the vehicle documents. Observe the maximum
permissible gross weight of the caravan. Your ERIBA dealer will be pleased to advise you.
12.6 Vehicle Identification Plate
The vehicle identification plate (Fig. 100) with
the serial number is mounted near the conver-
sion door.
Do not remove the vehicle identification plate.
The vehicle identification plate:
- identifies the vehicle
- helps with the procurement of spare parts
- together with the vehicle documents identi-
fies the vehicle owner
Fig. 100 Vehicle identification plate
A = Serial number
B = Chassis number
C = Maximum permissible gross weight of the caravan
D = Permissible axle load
E=Free
F = Permission number
Every alteration of the original condition of the caravan can jeopardize road safety.
The accessories recommended by HYMER AG and the original spare parts have
been specially developed for your caravan and supplied by us. Your ERIBA dealer
carries these products. The ERIBA dealer is informed about admissible technical de-
tails and carries out the required work correctly. The use of accessories, parts and fit-
tings not supplied by HYMER AG may cause damage to the vehicle and jeopardize
road safety. Even if an expert’s report, a general type approval or a design certifica-
tion exists, there is no guarantee for the proper quality of the product. No responsibil-
ity can be taken for damage caused by products not provided by HYMER AG or by
non permissible alterations.
> Always include the serial number
with all inquiries for the customer
service office.