Instruction manual

59T-Modell - 13/14 - Ausgabe 08/13 - 2354677 - BUE-0029-14EN
Pitching the motorhome
5
Extending:  If the vehicle is equipped with pneumatic springs: First lower the pneumatic
spring (see section 4.7.2 and 4.7.3), then extend the steady legs.
 Press the push button (Fig. 39,1) for approx. 2 seconds until a brief sound
is emitted. The steady legs control is now activated.
 Press and hold the preselection button for the steady leg side (Fig. 38,2
or 4) for approx. 1 second.
 Within 2 seconds, press the "Extend steady leg" button (Fig. 38,3) and hold
it until the support leg (Fig. 40,4) is touching the ground.
 Press the preselection button for the other steady leg side and repeat the
procedure.
Retracting:
 If the vehicle is equipped with pneumatic springs: First raise the pressure
in the pneumatic spring (see the manufacturer's instruction manual), then
retract the steady legs.
 Press the push button (Fig. 39,1) for approx. 2 seconds until a brief sound
is emitted. The steady legs control is now activated.
 Press and hold the preselection button for the steady leg side (Fig. 38,2
or 4) for approx. 1 second.
 Within 2 seconds, press the "Retract steady leg" button (Fig. 38,1) and
hold it until the support leg (Fig. 40,4) is fully retracted. Once the support
leg is fully retracted, a control signal sounds.
 Press the preselection button for the other steady leg side and repeat the
procedure.
Changing the remote
control battery:
 Remove the rear casing.
 Change the battery (CR2032). Observe the correct polarity ("+" to the out-
side).
Emergency operation If the electric drive breaks down, the steady legs can be moved with the hand
crank.
Fig. 39 Push-button to activate remote
control
Fig. 40 Electrical steady leg on vehicle
Z Do not extend the steady leg to the end position without it being in contact
with the ground.
Z The battery must be changed if the control LED flashes more slowly or if it
goes out.