Instruction manual

44 T-Modell - 13/14 - Ausgabe 08/13 - 2354677 - BUE-0029-14EN
During the journey
4
A pneumatic spring keeps the vehicle at the same driving level in every loading
condition. Additionally, different functions are operated manually. The
increase of ground clearance simplifies e.g. driving onto ferries (bigger gra-
dient angle).
4.7.2 Rear axle pneumatic spring
The different functions of the pneumatic spring can be operated manually via
the remote control buttons.
The following functions can be selected via the buttons:
X In the following cases, do not drive faster than 25 km/h (15 mph):
- While the vehicle is being raised.
- While the vehicle is being lowered.
- When the driving level is raised or lowered.
Then drive at a higher speed once the driving level is set.
Z When the vehicle is stationary, the button functions are only available if the
ignition is switched on.
When driving, the button functions are only available for speeds under
25 km/h (15 mph).
Z If the speed exceeds 25 km/h (15 mph), the driving level is controlled auto-
matically.
Fig. 27 Remote control
1 Indicator lamp
2 Raise level
3Lower level
4 Axle indicator
5 Driving level
6 Stop button
7 Storage 2
8 Storage 1
Function Button Display Signification
Start the system
(switch on the ig-
nition)
LED lights up for a
second
System ready
LED lights up Vehicle in driving
level
Set driving level
Press shortly
LED lights up Vehicle is set to
driving level
Raise the vehicle
Press until the de-
sired level has
been reached
Button blinks Vehicle is raised
Release Button lights up Level reached
Press shortly
Button blinks Vehicle is raised
Button lights up Highest level
reached