Instruction manual

27T-Modell - 13/14 - Ausgabe 08/13 - 2354677 - BUE-0029-14EN
Before the journey
3
Bike rack, not lowerable
The bike rack (Fig. 5,2) permits to easily transport 2 bicycles. Expansion for
3 bicycles is possible.
Loading the bicycles:
 Fold the telescopic swivel clip (Fig. 5,4) down.
 Place the bicycles on top and secure them with quick straps (Fig. 5,3).
 Fasten the spacer (Fig. 5,1) to the frame of the outermost bicycle.
3.3.7 Bike/e-bike bike rack (special equipment)
Z Also read the manufacturer's instruction manual.
Fig. 5 Bike rack, not lowerable
X Observe the permissible axle loads and maximum permissible gross
weight when loading the bike rack.
X Bicycles may protrude at the side by a maximum of 40 cm, measured
from the outer edge of the tail lights. However, a total width of 2.5 m must
not be exceeded. Adjust the attachments for the bikes accordingly. The
lateral overhang must be marked with a red flag.
X Do not attach more than 2 bikes (including e-bikes, pedelecs) to the bike
rack.
X Lock bike rack in drive position before starting your journey.
X Fasten bicycles using the straps provided and check to see that they are
secure after you have driven a few kilometres.
X Check the secure attachment of the bicycles on the bike rack after the
first 10 km and then at each break in the journey.
X Do not use the bike rack as luggage rack or ladder.
Z The bike rack is designed only to carry bicycles and electrically assisted
bicycles (e-bikes, pedelecs).
Z The gross weight specified by the manufacturer must not be exceeded.
Z The identification plate and rear lights must not be covered.
Z The maximum permissible payload of the bike rack is 100 kg.
Z When loading the bike rack, observe the centre of gravity. If the bike rack
is only loaded with one bicycle, position the bicycle as closely as possible
to the vehicle wall.