Instruction manual

202 T-Modell - 13/14 - Ausgabe 08/13 - 2354677 - BUE-0029-14EN
Sanitary fittings
10
10.7.1 Preparing toilet
 Open the flap for the sewage tank on the outside of the vehicle. Insert the
key into the locking cylinder of the push-button lock (Fig. 248,1) and turn a
quarter turn.
 Remove the key.
 Press both push-button locks (Fig. 248,2) simultaneously with your thumb
and open the flap.
 Pull up the retaining clip (Fig. 249,3) and use the handle (Fig. 249,2) to lift
the sewage tank (Fig. 249,1) straight up.
 Tilt the sewage tank slightly and remove fully.
 Put the sewage tank down vertically.
 Turn the drainage neck upwards.
 Remove the cap of the drainage neck.
 Fill the stated amount of sanitary liquid into the sewage tank.
 Then add enough water so that the bottom of the sewage tank is com-
pletely covered.
 Close drainage neck with the cap.
 Return the drainage neck to its original position.
 Push the sewage tank back to its original position without applying any
force.
 Ensure that the sewage tank is secured by the retaining clip.
 Lock the flap for the sewage tank.
Z The sewage tank (cassette) can only be taken out if the sliding trap is
closed.
Fig. 248 Flap for sewage tank Fig. 249 Sewage tank
Fig. 250 Turning drainage neck Fig. 251 Filling with sanitary liquid