Instruction manual

194 T-Modell - 13/14 - Ausgabe 08/13 - 2354677 - BUE-0029-14EN
Sanitary fittings
10
10.2 Water tank
10.2.1 Volumes
10.2.2 Drinking water filler neck with cap
The drinking water filler neck is on the right or left side of the vehicle,
depending on the model.
The drinking water filler neck is indicated by the symbol " " (Fig. 237,1). The
cap is open and closed using the key for the external flap locks.
Opening:
 Insert key into locking cylinder (Fig. 237,2) and turn a quarter turn in an
anticlockwise direction.
 Remove cap.
Closing:
 Place cap on the drinking water filler neck.
 Turn key one quarter turn in a clockwise direction.
 Remove the key.
 Check that the cap sits firmly on the drinking water filler neck.
Z The water tank contains 120 litres. However, the volume has been limited
to 60 litres (overflow installed) for payload reasons. The panel has not been
adjusted to this volume. The level indicator on the panel shows the actual
amount of water in the tank.
If necessary or if there is a sufficiently large residual vehicle payload, the
water tank can be filled up to its actual capacity. To do this, close overflow.
The handle is on the water tank.
Fig. 237 Cap for the drinking water filler
neck