Instruction manual

187T-Modell - 13/14 - Ausgabe 08/13 - 2354677 - BUE-0029-14EN
Appliances
9
 Press the button for the desired energy type or the automatic "AES" mode.
 Use the temperature range selection button (Fig. 229,7) to set the refriger-
ating temperature. The indicator lamps (Fig. 229,8) show the selected ther-
mostat position.
When operated with 12 V, the refrigerator draws power only from the living
area battery.
Switching off:
 Press and hold the On/Off button (Fig. 229,1) for about 2 seconds. The
refrigerator switches off and no displays are lit.
 Close the gas isolator tap "Refrigerator" and the regulator tap on the gas
bottle.
Additional functions In automatic mode, "AES" and the type of power currently in use are dis-
played. The brightness of the display is reduced after a few seconds if no other
buttons are pressed. When the door is opened, the interior light goes out after
2 minutes. If the door is open for longer than 2 minutes, the operating indicator
lamp flashes and a warning signal sounds.
9.6.4 Operation (Thetford with SES)
Operating modes The refrigerator is equipped with an automatic system to select the type of
power (SES). The "SES" automatically selects the optimal energy source and
regulates the refrigerator operation. Manual operation to select the type of
power is not required.
The SES selects from the following energy sources in the "Automatic" oper-
ating mode:
z 230 V AC
z 12 V DC
z Gas
Choosing the available energy source highest on the list.
The previously set operating mode is preselected when the refrigerator is
switched on.
Z If the refrigerator is manually set to "12 V", it will constantly consume cur-
rent. Therefore, switch over to gas operation when the vehicle engine is
not running, and the vehicle is not connected to the 230 V power supply.
Z Further information can be obtained from the separate instruction manual
"Refrigerator".
Z Further information can be obtained from the separate instruction manual
"Refrigerator".