Instruction manual

170 T-Modell - 13/14 - Ausgabe 08/13 - 2354677 - BUE-0029-14EN
Appliances
9
9.3.2 Telair
To execute the individual switching commands, always point the remote con-
trol in the direction of the receiver.
Operating modes
z Automatic
z Cooling
z Heater
Switching on:
 Press the "ON/OFF" button (Fig. 210,7).
 Press the "Mode" button (Fig. 210,10) as often as required until the
required mode (Fig. 210,1, 2 or 3) is indicated on the display. The corre-
sponding indicator lamp on the diffusor display (Fig. 211,3) lights up.
 Use the temperature increase button (Fig. 210,6) or temperature reduction
button (Fig. 210,8) to set the required temperature.
 Use the ventilation speed button (Fig. 210,9) to select the required ventila-
tion level.
Z Always wait at least 2 minutes between switching off and switching on
again. Otherwise the compressor will be damaged.
Z If the unit is operating, always open at least one ventilation flap.
Z The air conditioning unit only runs if the vehicle is connected to a 230 V
power supply.
Z In the winter, vehicle heating can be supported but not replaced by the air
conditioning unit.
Z Following switch-on the air conditioning unit needs approx. 3 minutes until
the compressor starts to run and cold air or hot air is output.
Z Also read the manufacturer's instruction manual.
Fig. 210 Remote control
1 Symbol for automatic
2 Symbol for cooling
3 Symbol for heater
4 Temperature (set) display
5 Fan speed display
6 Temperature increase button
7 "ON/OFF" button
8 Temperature reduction button
9 Ventilation speed button
10 "Mode" button
11 Display
Fig. 211 Display on the diffusor
1 Mains connection indicator lamp
2 Temperature (current) display
3 Mode indicator lamp
Green: Cooling
Red: Heater