Instruction manual

160 T-Modell - 13/14 - Ausgabe 08/13 - 2354677 - BUE-0029-14EN
Appliances
9
When the boiler is filled, the yellow indicator lamp (Fig. 195,8) indicates the
water heating phase.
The circulation fan automatically switches on when the heater is activated.
Switching off:
 Set the rotary switch (Fig. 195,3) to " " (Fig. 195,4).
After switching off the heater, the circulation fan may still run for a moment to
use up the residual heat.
Summer operation It is not possible to heat the vehicle in "Summer" operating mode. In "Summer"
operating mode, only the water in the boiler is heated.
9.2.5 Alde hot-water heater (special equipment Nexxo)
The hot-water heater is installed at the bottom of the wardrobe or under the
beds.
Operating unit The operating unit is divided into two sections:
z Display (touch screen)
z Control buttons
Z Further information can be obtained in the manufacturer's instruction
manual.
Z Never run hot-water heater without heating fluid. Observe notes in
chapter 12.
Z Never drill holes in the floor. This might damage the hot-water pipes.
Z The circulating pump must always be turned on when the hot-water heater
is in operation.
Z We recommend to bleed the heating system after the initial heater opera-
tion and to check the glycol content. Observe notes in chapter 12.
Z When the heater is turned on, it starts with the last settings used.
Z For further information, see the separate manufacturer's instruction manual
and observe the maintenance instructions found in chapter 12.
Z For further information about the use of the boiler see section "Boiler".
Fig. 196 Operating unit for hot-water
heater
1 Display (touch screen)
2 "Menu" button
3 On/Off button
Z When no button is pressed, the operating unit automatically switches to
home position after two minutes.
Z Changes to the settings are saved automatically after 10 seconds.