Instruction manual

102 T-Modell - 13/14 - Ausgabe 08/13 - 2354677 - BUE-0029-14EN
Living
6
Emergency operation If the pull-down bed can no longer be moved using the manual control unit
(e.g. loss of the vehicle's power supply or misalignment of the pull-down bed),
the pull-down bed must be manually operated. To do this, proceed as follows:
 Depending on the model, open the flap of the wall-mounted cupboard
(Fig. 119,1) and remove the cover from the access port (Fig. 119,2).
 Remove the pull-down bed mattress and reduce loading the storage cup-
boards as much as possible (to avoid the pull-down bed from swinging
back and forth)
 Detach the pin and cotter pin (Fig. 120,2) between the push rod
(Fig. 120,1) and lever (Fig. 120,3).
 Move the pull-down bed manually into the upper park position and tempo-
rarily secure it.
 Contact customer service.
6.13 Converting seating groups for sleeping
The seating groups installed in the vehicles can be divided into three catego-
ries:
z Individual bench seats that can be converted into an emergency bed.
z Seating groups with a lateral individual seat or lateral bench seat, which
can be converted into a transverse bed.
z Seating groups with bed widening, which can be converted into a length-
wise bed.
The following table gives an overview of the seating groups installed in the dif-
ferent models and names the section in which the bed conversion is
described.
Fig. 119 Access to drive Fig. 120 Drive
Z The ground plans for the individual models are shown in chapter 16.