User guide

Using your phone

Switching on

1 Ensure that a valid SIM card is installed and that either:

• The power adapter is attached (as discussed in the previous section),

• The internal battery has been charged for at least two hours (or

until the display shows ‘charged’) before it is used without mains

connection.

Whenever power is applied, the internal battery will be charged

automatically.

2 On the rear panel, press and hold the

red button for roughly one second, then

release.

• The screen should illuminate and

display an initial message while the

phone prepares itself for operation.

• If the SIM card is conﬁgured to use a

PIN (Personal Identiﬁcation Number)

code, you will be asked to enter it.

Enter the appropriate four digit code

and press the

Select button.

Note: take care when entering a PIN code as three successive incor-

rect tries will cause the SIM card to be blocked, requiring a special

unblocking code from your service provider.

• If there is no available network service in the vicinity, the display will

show

Searching... If this condition continues, try a different location

for the phone or antenna.

3 The standby screen will be displayed (see opposite).

Switching off

1 Press and hold the red button until the display goes blank.

Notes

During normal use, the phone should only be switched on and off using

the red button. Use the transit switch only after the unit has been turned

off.

If the transit switch is inadvertently moved to the locked position, the

phone will immediately shut off or enter a charging state if the power

adapter is connected.

Red

power

button