User manual

These commands support the setting of various facilities and conditions for
both terminal and telephone related functions.
Terminal settings
Display contrast (press 0# followed by 511)
Place the unit in the preferred operating position and use the * and # keys to
change the contrast of the LCD display. When the contrast is optimal, press 0 to
save the setting.
Security settings
SIM PIN state (press 0# followed by 5121)
This function is used to specify if the SIM PIN is required. If the facility is
enabled, every time the unit is powered up or logged on the PIN will be required.
If the PIN is incorrectly entered, the number of tries remaining (3 in total) is
displayed. If the number of tries expires, the PUK (PIN Unblocking Code) will be
required and this must be entered using the **05* code (see pages 29 and 34).
Change SIM PIN (press 0# followed by 5122)
This function allows a new PIN to be set. The old PIN is first requested followed
by the new PIN, which also needs to be repeated. If the OLD PIN is incorrectly
entered, the security measures apply where the number of tries to change the
PIN are displayed and after 3 failed attempts the blocked state is entered and the
PUK is required.
Terminal PIN state (press 0# followed by 5123)
This specifies if the terminal PIN is required. The terminal PIN is used to prevent
unauthorised use of the terminal and also for remote monitoring and control
functions. If the terminal PIN is enabled, the unit will request the PIN when
power is applied, or if the remote monitoring and control mode or Terminal lock
mode is being used. See the section on terminal mode (page 18).
Change terminal PIN (press 0# followed by 5124)
The old PIN must be entered correctly then the new PIN needs to be entered
twice before it is accepted. The PIN is fixed to 4 digits in length and defaults
to 1234.
This section supports the facility to divert voice calls to another number.
To control the DATA, SMS and FAX divert facilities, use the *# codes (see
Appendix). For diverting to voicemail, see the instructions provided by your
service provider.
Each of the divert menus (41,42,43,44) are provided with three sub-menus for
Activate, Cancel and Status.
When activating a diversion, a phone number must be specified or a phonebook
entry used to provide the number. Once a number is entered, it is “registered” in
the network.
When cancelling a diversion, the previously registered number is retained.
When reactivating a divert, you are given the opportunity to delete the currently
registered number or enter a new number. To just delete the number, hang after
deleting. Otherwise continue be entering a new number or editing the existing one.
To view the current state of forwarding for a given type, use the status function.
If forwarding is active, the destination number that calls are forwarded to will be
displayed. When viewing the status, it is possible to step to the cancel menu and
conveniently cancel the divert.
Divert all (press 0# followed by 41)
All voice calls are diverted.
Divert when busy (press 0# followed by 42)
Diversion of voice calls received when the phone is busy.
Divert no answer (press 0# followed by 43)
Voice calls received but not answered will be diverted after 20 seconds.
Divert when off (press 0# followed by 44)
Diversion of voice calls made to the terminal when the unit is either powered off
or off-air (see menu item 63 on page 18).
Cancel diverts (press 0# followed by 45)
All call forwarding conditions will be cleared.
Section 10
Call divert – 4
14 15
Section 11
Settings – 5