User manual

The inbox and outbox messages are stored in the SIM memory and the number
of messages available varies depending on the capacity of the SIM. The most
recent edited message and the sensor messages (see page 25) are stored in the
terminal's internal memory and this information is retained even when the power
is removed.
Write messages (press 0# followed by 21)
Messages are composed with this function.
Start entering your text. (See the section on text entry page 27). The display
shows the number of characters remaining before the message memory is full
(total of 160) on the top right of the display.
Once the message is complete and the cursor is at the end of the message,
press # again and the prompt “Save to outbox?” will be displayed. Press 0 to
accept or press # again to enter the phone number or search the phonebook.
After selecting the destination number, press # again and the message will be
sent. To go back, press the * key.
If the message memory contains any text from a previous message, you will be
prompted “Clear existing message?” To clear the memory, press 0, otherwise
press # to start editing the previous text.
Inbox (press 0# followed by 22)
This is where incoming messages are stored.
To view a message, select the inbox from the menu and press 0. The display will
show a list of messages in the inbox. The list is shown in chronological order.
An icon indicates if a message has been read or not and the phone number that
sent the message. Move up and down the list and press 0 when you reach the
entry you want. The date and time that the message was sent will then be
displayed. Press # again and the message text will be shown.
(Tip: key 0# quickly to skip to the text)
Scroll through the message using the * and # keys. By pressing # again you will
be prompted to delete the message. If you want to delete, press 0 otherwise
press * to return to viewing the message.
10 11
Messages – 2
Section 8
Phonebook – 1
Section 7
Edit (press 0# followed by 13)
Select the entry you want to modify by entering the first letter of the name or #
to scroll through the entries. Once selected, the entry cursor will show at the
start of the name text. Edit the text as required. Press # to display the number.
Edit the number as required. (To skip to the end of the entry press and hold #).
Press # again and the changes will be saved. If you hang up at any time before
this, the changes will be discarded.
Status (press 0# followed by 14)
This displays the number of phonebook entries used and the number available.
Erase single entry (press 0# followed by 151)
Use this function to erase an individual phonebook entry.
Select the entry you want to erase by entering the first letter of the name or #
to scroll through the entries. Once selected press 0 again to confirm erase.
This can be aborted at any time before the “Erased” message appears by
pressing * to go back or hanging up.
Erase all entries (press 0# followed by 152)
Use this function to erase the entire contents of the phone book.
This function is protected from accidental use by requiring the terminal PIN
to be entered first. Once correctly entered, confirm by pressing 0.
The erasing process takes about 15 seconds for 200 entries.