User manual

To use the terminal you will need:
f a suitable SIM,
f a normal touch-tone telephone with alpha characters on the keypad
(preferably one that displays caller ID)
f a power source.
Step 1 - Installing a SIM
1. Remove the SIM tray by pressing the ejector button using a suitable pointed
object such as a ballpoint pen. After the tray has ejected about 2mm, pull it out
completely with your finger and thumb. Note how
the tray slides into guides. See Figures 2 and 4.
2. Place your SIM with gold contacts upper most into
the tray by placing corner A against side A of the
SIM tray See Figure 3.
3. Now lower the SIM and press it snugly into the tray. The SIM must sit
flush
with the tray.
4. Insert the SIM tray with the SIM back into the slot
and press it all the way until the tray becomes
flush with the panel. Note:
make sure that the
tray slides correctly in the guides.
4 5
Section 2
Getting started
RS232 computer
connection (1)
Antenna
connection (2)
Telephone
connection (6)
SIM tray(5)
SIM ejector (4)
DC input (3)
Input(s)/Output (7)
A
A
Figure 2: View of rear
Figure 3
Figure 4
Making the connections
Ensure that the following steps are followed accurately as there may be a risk of
damage to the unit if sockets are wrongly connected.
Step 2 – Connecting the antenna
To socket 2, attach the supplied antenna or another GSM antenna with a suitable
connector
1
. The connector nut only needs to be finger tight, do not apply
excessive force.
Locate the antenna in a convenient position at least one meter from your
telephone to avoid interference. If the signal strength is not strong, you may
need to adjust the position of the antenna. Use the signal strength indication
(see page 32) to find the optimum location.
Step 3 – Connecting a telephone
Connect a touch-tone phone to socket 6. If your phone has a different connector
from the standard
2
, use an adaptor (supplied in some kits).
Step 4 – Connecting the power
To socket 3, connect the DC power connector from the supplied mains adaptor
or a suitable alternative.
Step 5 – Apply power
Apply power and the terminal display
will momentarily show the product
name and the software version. It will
then show the date and time, signal
strength and network operator.
You are now ready to make your first call.
Section 2
Getting started
1 FME Female connector
2 RJ11 type
Figure 5: Keep the antenna away from the telephone
1 meter minimum