Instruction Manual

EN
12
• The rst time the product is used it may
smoke and smell a little. This is a result of
a normal chemical process that makes the
heat-resistant enamel harder. Allow the
re to burn for at least 40 minutes before
cooking food.
SYMBOLS
Read the instructions.
TECHNICAL DATA
Size H49xØ30cm
Weight 3,4kg
USING AS A FLOWER POT
• Place the product on a level surface.
• Water plants with a watering can,
or equivalent.
• Do not water with a hose.
• Leave 5 cm between the surface of the
planting soil and the top edge of the
product.
• Avoid scratching or otherwise damaging
the enamel, this can result in corrosion.
MAINTENANCE
Enamelled model
The product is treated with heat-resistant
enamel that withstands temperatures of up to
600°C, but it is not galvanised. Any scratches
and wear during use can therefore in time
damage the surface treatment and result in
corrosion.
This will not aect the functionality or capacity
of the product. It is recommended to touch
up the product with heat-resistant enamel at
least once a year for best functionality and life
span. Follow the instructions of the enamel
manufacturer.
SAFETY INSTRUCTIONS
Always follow the instructions.
• The product is only intended for outdoor
use with wood as fuel. Do not use the
product to burn refuse.
• Place the product on a level, non-
ammable surface that can withstand rust
stains.
• Never leave the product unattended when
it is lit.
• Place the product at least 5 m from
ammable material when in use and
make sure that the area above the
product is clear.
• Never move the product when it is lit –
risk of re and/or burn injury. Wear safety
gloves when handling the hot product.
Avoid if possible handling or moving the
product before it has cooled.
• Never use petrol, alcohol or other
ammable substances in the product.
• Keep children and pets at a safe distance
from the product.
• Never attempt to extinguish the ames
with water. Use sand.
• Do not ll the product with wood to more
than 2/3 full before lighting.
• Never light the product in strong wind.
Extinguish the re if a strong wind starts
blowing when in use.
• Always check after use that the product is
clean and undamaged and that the metal
is not badly burnt.
• The enamel can become discoloured at
hot temperatures. This is a natural process
and does not aect the capacity of the
product.
• Avoid scratching or otherwise damaging
the enamel, this can result in corrosion.
• Do not expose the product to rain or
snow.
• Very high temperatures can result in
minor damage to the enamel on the
inside of the product.