User guide
70
FIG. 61
PILOT FLAME
HONEYWELL Q179D PILOT W/THERMOCOUPLE
SECTION V – SERVICE (continued)
FIG. 62
PILOT FLAME
HONEYWELL Q179C PILOT
FIG. 63
PILOT FLAME
HONEYWELL Q327A PILOT W/THERMOCOUPLE
7. LOW WATER CUT-OFF –
a. Float Type Low Water Cut-off
Duringtheheatingseason,ifanexternallowwater
cut-off is on the boiler, the blow off valve should
be opened once a month (use greater frequency
whereconditionswarrant),toushoutthesediment
chamber so the device will be free to function
properly.
Low-water fuel cut-offs and water feeders should
bedismantledannuallybyqualiedpersonnel,
totheextentnecessarytoinsurefreedomfrom
obstructions and proper functioning of the
working parts. Inspect connecting lines to boiler
for accumulation of mud, scale, etc. and clean as
required.Examineallvisiblewiringforbrittleor
warn insulation and make sure electrical contacts
are clean and that they function properly. Give
specialattentiontosolderjointsonbellowsandoat
whenthistypeofcontrolisused.Checkoatfor
evidence of collapse and check mercury bulb (where
applicable) for mercury separation or discoloration.
Do not attempt to repair mechanisms in the eld.
Complete replacement mechanisms, including
necessary gaskets and installation instructions, are
available from the manufacturer.
regulator 5.5” WC in pilot line so that a medium hard
centerameenvelopsamerod,seeFig.61.Ifame
is yellow, primary air opening may be covered with dirt
or lint. This can be removed with a soft brush or by
vacuuming.
The EP Control Systems utilize a Honeywell Q179C
FlameRecticationPilot.Adjustpilotlineregulator
(5.5” WC in pilot line) so that a medium hard center
ameenvelopsamerod,seeFig.62.Ifameis
yellow, primary air opening may be covered with dirt
or lint. This can be removed with a soft brush or by
vacuuming.
The Thermocouple Control System utilizes a
Honeywell Q327A non-primary aerated pilot with a
Q309Athermocouple.Adjustpilotlineregulatorto
giveasteadyameenveloping3/8”to1/2”ofthetipof
thethermocouple,seeFig.63.










