Operating instructions

@)
INSTALL FLUSH JACKET
in
accordance
with
Fig.
9.
Refer to Figure
4
for knockouts to be removed.
@)
INSTALL TOP PANEL WlTH FLANGES
POSITIONED OUTSIDE REAR AND SlDE
PANELS. SECURE WlTH S.M.S.
@
REMOVE NECESSARY KNOCKOUTS.
DO NOT TIGHTEN ANY S.M.S.
UNTIL ALL PANELS HAVE BEEN TOP
PANEL
INSTALLED.
@ASSEMBLE LEFT HAND SIDE
PANEL TO FLANGE ON FRONT PANEL WITH S.M.S. LEAVING UPPER HOLE VOlD UNTIL
INSTALLATION OF TOP PANEL.
I"
BLOCKS UNDER REAR OF
SlDE PANELS WILL FACILITATE
ASSEMBLY.
@I
ATTACH LOWEST
WATER PLATE USING S.M.S.
@.
@
PLACE FRONT PANEL IN POSI-
TION BY SLIDING DOWN BEHIND
BURNER PLATE FLANGE. ASSEM-
BLE TO FRONT PANEL FILLER
PIECE
WITH S.M.S.
&
D
ATTACH RATING PLATE
I
HERE USING S.M.S.
INSTALL FRONT PANEL FILLER
PIECE BELOW BURNER PLATE
POSITIONING BEHIND FLANGE. FRONT PANEL FILLER PIECE
-----k?
S-.
'3
REAR
PANEL
UPPER
RlGHT HAND PANEL
@
PLACE REAR PANEL IN POSITION
AND
ATTACH LEFT AND LOWER RlGHT HAND
SlDE PANELS TO FLANGES ON REAR
PANEL WlTH S.M.S.
@
INSTALL UPPER RlGHT HAND SlDE
PANEL BY SLIDING DOWN UNTIL
BOTTOM FLANGE IS FULLY SEATED
BEHIND LOWER RlGHT HAND SlDE
PANEL. ATTACH TO FLANGES ON
FRONT AND REAR PANELS WITH S.M.S.
LEAVING UPPER FRONT HOLE
VOlD
UNTIL INSTALLATION OF TOP PANEL.
LUWtK
RlGHT HAND
'%
1
@
ASSEMBLE LOWER RIGHT HAND SlDE PANEL
PANEL FLANGE ON FRONT PANEL WITH S.M.S.
FLUSH JACKET ASSEMBLY
Fig.
9