Install Instructions

d. Excessive airow or draft causing ame to leave

burner head.

e. Excessive back pressure causing ame to be

erratic.

3. Control locks out after Trial For Ignition (TFI).

a. No oil to burner.

b. Shorted electrodes.

c. Nozzle clogged.

d. Airow too high.

e. Ignitor module defective.

f. CAD cell defective.

g. Oil valve stuck open or closed.

Note: The Safety Monitoring Circuit (SMC) is

designed to provide lockout in the event of a

stuck or welded motor relay.

NOTICE

If ame is not established within 15 seconds

of oil valve actuation (known as Trial For

Ignition [TFI]) lockout will occur. Lockout is

indicated by a red LED solid-on located on the

oil primary control.

Latch-up will occur if the control locks-out

three (3) times during a call for heat. This

is indicated by steady-on red and amber

LED's.

Not Applicable to Riello 40 Series Burner,

refer to Models F3 and F5 Installation Manual, Riello 40 Series Residential Oil

Burners (C6501010).

SECTION XI: TROUBLE SHOOTING (continued)