Product Overview

11
103859-12 - 8/19
MPO-IQ
Installation & Service Manual
A. REMOVE CRATE.
1. Remove all fasteners at crate skid.
2. Lift outside container and remove all other
inside protective spacers and bracing. Remove
miscellaneous parts carton.
B. REMOVE BOILER FROM SKID.
1. To reduce the risk of damage to boiler jacket, use
the following procedure to remove from skid, see
Figure 3:
Step 1. Boiler is secured to base with (4) 5/16" cap
screws, (2) in front and (2) in rear of shipping skid,
see Figure 3. Remove all securing hardware.
Step 2. Place wooden block(s) 12" from rear of
skid as shown (one piece 4" x 4" x 16" lg. or two
pieces of 2" x 4" x 16" lg.)
Step 3. Insert 1" Sch. 40 pipe handles through leg
hole in front and rear legs. Center end of pipe
on wooden blocks as shown in Figure 3.
NOTE: Pipe handles should extend a minimum
of 48" beyond jacket front panel for best leverage.
Step 4. Using the pipe handles, lift boiler until
adjustable legs are elevated above the deck
boards.
Step 5. Remove skid from underneath the boiler.
Step 6. Lower pipe handles until front adjustable
legs touch floor. If necessary, place wooden
blocks under front legs before lowering to provide
hand clearance.
Step 7. To lower rear of boiler, tilt boiler slightly
forward by pushing on smokebox collar or lift
pipes protruding through rear legs until wooden
blocks can be removed (see Figure 3). Slowly
allow the weight of the boiler to tilt backward until
rear legs rest on floor.
Step 8. If wood block was placed under front legs,
lift pipe handles, remove wooden block and lower
front legs to floor. Remove pipe handles.
CAUTION
Do not drop boiler. Do not bump boiler jacket
against floor.
C. MOVE BOILER TO PERMANENT POSITION by
sliding or walking.
D. PROCEDURE TO OPEN, CLOSE AND SECURE
BURNER SWING DOOR
Throughout this manual you will be instructed to open
and close the burner swing door for various reasons.
There is a proper and improper method to closing and
securing the burner swing door opened for inspection,
cleaning or field service.
1. TO OPEN BURNER SWING DOOR
(see Figures 4A and 4B).
Step 1. Loosen but do not remove left side
latching hardware (3/8" x 1-3/4" lg. tap bolt).
Step 2. Loosen and remove right side latching
hardware (3/8" x 1-3/4" lg. tap bolt and
washer).
Step 3. Remove left side latching hardware (3/8"
x 1-3/4" lg. tap bolt and washer).
Figure 3: Packaged Boiler Removal from Skid
2 Packaged Boiler Assembly - Trim & Controls
!