Alpine Installation, Operating, and Service Instructions

126
103448-10- 6/18
A. Continuously:
1. Keep the area around the boiler free from
combustible materials, gasoline and other
flammable vapors and liquids.
2. Keep the area around the combustion air
inlet terminal free from contaminates and
obstructions to combustion air flow.
3. Keep the boiler room ventilation openings
open and unobstructed.
B. Monthly Inspections:
1. Inspect the vent piping and outside
air intake piping to verify they are open,
unobstructed and free from leakage or
deterioration. Check rodent screens in vent
and air intake terminations to verify they are
clean and free of debris. Call the service
technician to make repairs if needed.
2. Inspect the condensate drain system to
verify it is leak tight, open and unobstructed.
Call the service technician if the condensate
drain system requires maintenance.
3. Inspect the flue temperature sensor cap
to verify that it is free from leakage and
deterioration. Call the service technician to
make repairs, if needed.
4. Inspect the water and gas lines to verify they
are free from leaks. Call the service technician
to make repairs if required.
C. Annual Inspections and Service: In addition to
the inspections listed above the following should
be performed by a service technician once every
year.
1. Follow the procedure for turning the boiler off
per Figure 35 “Operating Instructions”.
2. Inspect the wiring to verify the conductors are
in good condition and attached securely.
XI. Service and Maintenance (continued)
NOTICE Warranty does not cover boiler
damage or malfunction if the following steps
are not performed at the intervals specified.
NOTICE Water leaks can cause severe
corrosion damage to the boiler or other system
components. Immediately repair any leaks
found.
This boiler must only be serviced and repaired by skilled and experienced service
technicians.
• If any controls are replaced, they must be replaced with identical models.
• Read, understand and follow all the instructions and warnings contained in all the sections of this
manual.
• If any electrical wires are disconnected during service, clearly label the wires and assure that the wires
are reconnected properly.
• Never jump out or bypass any safety or operating control or component of this boiler.
• Read, understand and follow all the instructions and warnings contained in ALL of the component
instruction manuals.
• Assure that all safety and operating controls and components are operating properly before placing the
boiler back in service.
• Annually inspect all vent gaskets and replace any exhibiting damage or deterioration.
WARNING
DANGER
Explosion Hazard. Electrical Shock Hazard. Burn Hazard. This boiler uses flammable
gas, high voltage electricity, moving parts, and very hot water under high pressure. Assure that all
gas and electric power supplies are off and that the water temperature is cool before attempting any
disassembly or service.
Do not attempt any service work if gas is present in the air in the vicinity of the boiler. Never modify,
remove or tamper with any control device.