Burley STROLLER Kit ® d’lite ™ Euro d’lite ™ Lady Bug ™ Encore ™ Solo ™ Cub ™ Owner’s Instruction and Safety Manual
Congratulations! By purchasing the Burley Stroller Kit, you’ve increased the fun and excitement that you and your family can have with your Burley child trailer. IMPORTANT: Because some of the features and guidelines for using your Burley merit close attention, it is very important that you familiarize yourself with the Stroller by reading this entire manual and your Burley Trailer manual before use. If you have any questions, please contact your Authorized Burley Dealer or check our website at www.
WARNING Failure to observe all of the safety guidelines in this manual could result in an accident and serious injury or death. Safety Guidelines Protect Your Children Never leave your children unattended in the Stroller, and always use the handle bar tether. Use the shoulder harnesses and lap belts to securely hold your children in the Stroller at all times. For maximum stability and safety, seat a single child in the center.
Observe Age and Height Restrictions The Stroller seat is intended only for children old enough to sit upright and alone. Adequate neck strength is required to hold his/her head upright. A physician should evaluate anyone who is of questionable developmental age for using this Stroller. Never carry a child whose sitting height is above the roll bar, because their chance of injury is significantly higher in the event of a tip over.
Re-Assembly with the Wheel Pivot Assembly in Place Slide the tongue into the wheel pivot assembly and line up the hole in the tongue with the hole in the top of the assembly. Run the provided 2 inch bolt through the grommet in the end of the safety strap, the holes in the wheel pivot assembly and the tongue, and finally the D-ring. Secure the bolt with the locking nut (tighten to 6 ft-lbs). The end of the bolt should be flush or completely pass through the end of the nut.
To Adjust the Tracking To adjust the tracking of the stroller wheel (which allows the stroller to roll straight), loosen set screw with 5/32" hex wrench, adjust the bushing with a 3/4" wrench. (See the illustration below or above). Turn the bushing until the wheel is perpendicular to the ground. Test the tracking by pushing the stroller away from you to make sure it rolls straight. Make any additional adjustments before putting your child in the trailer. When aligned tighten set screw.
WARNING When converting your Stroller to a bicycle trailer, make sure that the Stroller wheel is in the proper position before attaching the trailer to your bicycle. Do not use this product as a bicycle trailer without the retaining pin or bolt and safety strap properly installed. Failure to follow the instructions in this manual and your trailer manual can cause an accident resulting in serious injury.
Burley Stroller Kit Limited Warranty Burley will repair or replace parts it determines to be defective as follows: plastic parts for five years and durable frame parts for the lifetime of the Stroller Kit. The owner of a Burley Stroller Kit must present the Stroller Kit for repair at an Authorized Burley Dealer, together with an original sales receipt or similar proof of purchase. This warranty applies only to the original owner and is nontransferable.
